Talk:GIGABYTE GA-M57SLI-S4: Difference between revisions
Jump to navigation
Jump to search
(thf) |
(2 Mbit ? successreport thf) |
||
| Line 7: | Line 7: | ||
on GA M57SLI, is FWH mode used ? is it necessary to use different ID on ID-pins ? | on GA M57SLI, is FWH mode used ? is it necessary to use different ID on ID-pins ? | ||
---- | |||
''' | |||
badly in need:''' | |||
* report on usability of top hat flash on M57SLI | |||
* is it practical to upgrade the secondary pad with an 2 MBit flash part ? | |||
---- | ---- | ||
Revision as of 23:33, 9 May 2007
swap #CE and #WP and thus route #CE through the #WP jumper with 8 pin SPI possible ? --da Great QUUX 14:24, 28 April 2007 (CEST)
Alternatively, you might flip a standard plcc-32 socket over the mainboard-chip. then wire a secondary plcc-32 socket to it wired 1:1 - except you connect /reset and /oe on the replacment chip, while you route the /oe from the mainboard to an NC pin on the secondary chip. Take off (hot unplug) the socket after successful boot-up to reflash the original chip. (so called "top hat flash" method, use at own risk, no successful report on GA M57 yet)
on GA M57SLI, is FWH mode used ? is it necessary to use different ID on ID-pins ?
badly in need:
- report on usability of top hat flash on M57SLI
- is it practical to upgrade the secondary pad with an 2 MBit flash part ?