Intel Sandybridge Build Tutorial

Step by Step Tutorial How to flash coreboot onto Lenovo T520. Flashing coreboot on supported Intel SandyBridge / Ivybridge system is very similar to this one. Steps that need to be changed are marked as those.

Chapters:

• Check the board status
• Setup toolchain
• Get binary blobs
• Configure coreboot
• Build coreboot
• Flash coreboot
• Recovery and Debugging

For more information have a look at https://www.coreboot.org/Build_HOWTO

Get binary blobs

Coreboot needs some binary blobs. Here's a list of blobs required: Binary_situation

I'm going to use:

• Intel Management Engine (ME)
• Intel Flash descriptor (IFD)
• Intel Gigabit Engine (GBE)

Warning: Remove all batteries and unplug the power connector. You have to make sure to supply enough current through the programmer.

The Beaglebone Black onboard voltage regulator doesn't supply enough current. Using an external power supply may be required.

Some flash chips can't be programmed while soldered, as the southbridge is powered, too, and communicates with the flash.

The T520 flash IC can be programmed in circuit.

I used the TIAO USB board to access the flash. You need a flashrom version supporting the "tumpa" programmer. Of course you can read the flash using the Raspberry or BeagleBone, too. To read the flash chip using tumpa programmer:

flashrom -p ft2232_spi:type=tumpa,port=A,divisor=4 -r T520.bin

To read the flash chip using raspberry pi:

flashrom -p linux_spi:dev=/dev/spidev0.0 -r T520.bin

Extract the binary blobs from the raw flash image:

cd ./util/ifdtool
make
./ifdtool -x T520.bin

The following files will show up:

• flashregion_0_flashdescriptor.bin
• flashregion_1_bios.bin
• flashregion_2_intel_me.bin
• flashregion_3_gbe.bin